805 436 1100

Get a quote

Port 02 · Ubiquiti UniFi

Wifi that stops being
the reason for the ticket

Surveyed, cabled and configured UniFi networks. Every access point placed because a measurement said so, not because there was a spare ceiling tile.

Signal path: internet to gateway to switch to access points to your devices InternetGatewaySwitchAccess points your ISPfirewall · VPN · VLANsPoE · managedWiFi 6 / 7 your desks

Sound familiar

The complaint, and what’s actually causing it

“It drops when I walk to the back office.”

One access point trying to cover a footprint that needs three, or two fighting each other on the same channel. A survey settles it in an afternoon.

“Calls break up but the internet is fine.”

No QoS. Voice traffic is queuing behind somebody’s cloud backup. Voice gets its own VLAN and priority.

“We reboot the router every morning.”

Consumer gear doing a commercial job, usually out of DHCP leases or NAT sessions by 10am.

“Guests are on the same wifi as the till.”

A flat network. Guest, staff, voice and payment traffic should never see each other.

“Nobody knows the password, it’s on a sticky note.”

A guest portal with a rotating code, and staff devices on certificates instead of a shared secret.

“It only breaks when we’re busy.”

Access point client limits. Coverage was measured empty and never tested under load.

What goes in the rack

One dashboard, every site you run

U1UniFi gatewayFirewall, site-to-site VPN, VLAN routing, IDS/IPS
U2Managed PoE switch8 to 48 ports, powers the APs and the phones
U3Patch panel & cable managementCat6 runs, labelled at both ends, tested and certified
U4UPSThe phones stay up when the lights don’t
APWiFi 6 / WiFi 7 access pointsCeiling, wall or outdoor, placed from the survey
CAMCameras & door accessOptional, same dashboard, same cabling

How a job runs

Measure, cable, configure, watch

Step 01

Site survey

We walk the floor with a meter and a floor plan, note the wall construction, and mark where signal actually dies.

Step 02

Cable & mount

Cat6 pulled, terminated, tested and labelled. Done after hours if the room can’t be down.

Step 03

Configure

VLANs for staff, guest, voice and payments. QoS so calls win. Guest portal with your branding.

Step 04

Monitor

We keep an eye on it. Most of the time we know a switch has dropped before anyone reaches for the phone.

Next step

Tell us what’s not working

Send over your current phone bill or a floor plan and we’ll come back with a fixed quote. No discovery call required.

805 436 1100

[email protected] · Mon–Fri, 8am–6pm PT

Get a quote